bulletfishing®  Kontiki Timer - Magnet controlled for the DIYer

Designed and built by us in NZ specifically for one purpose only, and that's for salt water KONTIKI FISHING  

A MAGNET CONTROLLED ELECTRONIC TIMER BATTERY LEVEL MONITOR with Battery status indicator 

• 6 User defined timing periods complete with 6 "tell tale red or green LEDs" 
• 5, 10, 15, 20, 25 and 30 minutes selectable running time 
•  Low battery cutout to extend battery and motor life (as battery voltage drops current draw increases, melting plugs and blowing fuses). 
• Cast in epoxy resin, fully sealed and waterproof. 
• NZ made for Kiwi conditions 
• Length 102mm width 45mm Height 16mm approx 
• Switch on and the battery status will be shown ​
• Simply hold the magnet over the timing sensor and the LED light will advance until the desired timing period is reached, remove the magnet and the timing period is now set 
• Place the magnet over the STOP/START sensor and the selected LED will flash and the motor will run until the selected timing period has elapsed 
• If required to stop the motor place the magnet over the STOP/START sensor and the motor will stop 

**With free 80amp big terminal relay, for your own fishing torpedo / contiki 

• Sensitive enough to work through plastic or alloy 
• Reverse polarity protection 
• Magnet on lanyard included free 
• Decal included 
• To fit, drill 6 x 5mm holes at 10mm spacing, tap to 6mm, align timer inside hull, fill holes with hot melt glue. remove excess glue with stanley knife 
• Only 2 wires to make it go! 
• Red wire to battery positive Black wire to negative and connect relay between one of the motor wires to complete the circuit 

UV STABILISED COMPONENTS, WILL NOT DEGRADE IN SUNLIGHT 

12 MONTH WARRANTY 

*Protected by NZ and International intellectual property law*